Brick 600

Brick® 600 Heat Transfer Vinyl

Our thickest heat transfer vinyl - now easier to cut and apply!

Thin or thick, materials of all sizes have a place in garment decorating. Brick® 600 heat transfer vinyl by Siser® is a 600 micron thick, flexible heat transfer vinyl that’s designed for smaller logos and designs to add extra dimension to your garments. Brick 600’s matte finish looks great on caps, bags, and is ideal for left chest logos. This trendy look can be seen on sports apparel all over the globe. When used as a base layer and covered with EasyWeed® Stretch, the combination gives a great embossed look. The next time you feel your design could benefit from a boost in height, consider giving it some dimension with Brick 600 by Siser!

Brick 600 is 600 Microns / 23.6 Mils and is a PU composition.

Brick 600 is Layerable only if using the embossed method of heat application.

Brick 600 Features

 Brick 600 Shirt Design
Brick 600 White   Brick 600 Black   Brick 600 Red   Brick 600 Yellow   Brick 600 Green   Brick 600 Royal Blue   Brick 600 Navy Blue

Brick 600 Applies To:

Cricut:   Blade: Standard   Setting: Cardstock Light +
Silhouette Cameo:   Blade: Standard, 10   Material: Heat Transfer, Flocked   Speed: 4   Force: 33
Brother ScanNCut:   Blade: Standard, 10   Cut Speed: 1   Cut Pressure: 2


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Roland GX/GS-24:   Blade: 60°   Gram Force: 150-190   Offset: .250   Speed: 30 cm/s
Graphtec:   Blade: 60°   Force: 11-12   Tool: CB09U+0   Speed: 25 cm/s
MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 120-130   Speed: 300 mm/s    *Blade Advancing Varies
Titan 2 & 3:    Blade: 45°/60°    Gram Force: 100-110   Speed: 300 mm/s   *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with Kraft Paper or Heat Transfer Cover Sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 20 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 10-15 seconds
• Peel carrier cold		 Application Instructions (heat press)

• Cover design with Kraft Paper or Heat Transfer Cover Sheet
• Preheat garment for 2-3 seconds
• Apply design at 311°F/155°C
• Use medium pressure for 20 seconds
• Peel carrier cold

Click here for a printable version of all HTV application instructions

Recommended Accessories:

Siser Weeder
Multipurpose Paper or
Kraft Paper or
Heat Transfer Cover Sheet

Laundering:

Wait 24 hours before first wash
Machine wash cold / mild detergent
Dry on normal dryer setting
Do not dry clean