Twinkle

Twinkle Heat Transfer Vinyl

The Shining, Silcone Star of the Show!

Wishing for a heat transfer vinyl like no other? Well you can thank your lucky stars because your wish was granted with Twinkle HTV! Twinkle’s silicone-like surface holds brilliant colors that appear to practically shine their own light when the glitter winks and wavers. The intense sparkle gives Twinkle a slight, but significant reflective quality. Every color of Twinkle is topped with a mesmerizing glossy glaze that feels fantastic. Whether it’s the lone focus or an incredible accent, Twinkle is your new show stopping heat transfer vinyl!


Twinkle is 225 Microns / 9 Mils and is a PU composition.



Twinkle Features

Twinkle Shirt Design
Twinkle Silver   Twinkle Red   Twinkle Orange   Twinkle Gold   Twinkle Royal Blue   Twinkle Navy Blue   Twinkle Purple   Twinkle Fuchsia

Twinkle Applies to:




Craft Cutter Settings


    Cricut:
Blade: Standard    Setting: Glitter Iron-on

    Silhouette Cameo:    
Blade:
Auto-Blade, 3      Speed:     Force: 10

    Brother ScanNCut:    
Blade:
Auto-Blade    Cut Speed: 1    Cut Pressure: 4 * Half Cut On


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.




Pro Cutter Settings


    Roland GX/GS-24:
Blade: 45°    Gram Force: 130-160    Offset: .250    Speed: 30 cm/s

    Graphtec:    
Blade:
45°    Force: 13    Offset: .250    Speed: 35 cm/s

    MH, SC2, LP3, and Titan 1:    
Blade:
45°/60°    Gram Force: 120-130    Speed: 300 mm/s *Blade Advancing Varies

    Titan 2 & 3:    
Blade:
45°/60°    Gram Force: 100-110    Speed: 300 mm/s *Blade Advancing Varies

    Mimaki CG-60SR III:    
Blade:
45°    Gram Force: 95    Offset: 30    Speed: 20-30 cm/s


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.




Application Instructions


Home Iron Instructions

• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 15 seconds
• If areas of design lift after application, replace cover sheet and
re-press for 5-10 seconds
• Peel carrier warm

Heat Press Instructions     

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium/firm pressure for 15 seconds
• Peel carrier warm (at least 15 seconds off press)

Click here for a printable version of all HTV application instructions




Recommended Accessories:

Siser Weeder
Multipurpose Paper or
Heat Transfer Cover Sheet

Laundering:

Wait 24 hours before first wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean