Blackboard® Heat Transfer Vinyl

Write it, wipe it, repeat!

Now you can turn any fabric into a writable surface that can be used over and over again! New BlackBoard® heat transfer vinyl by Siser®, transforms plain materials into a walking chalkboard – without making you feel like a walking sandwich board! Lightweight and super soft, BlackBoard is unlike any HTV you’ve ever experienced. This revolutionary material only needs 275°F of heat with medium pressure for just 15 seconds to create a machine washable chalkboard! With a low application temperature and warm peel carrier, this HTV is ideal for heat sensitive materials.

Compatible with standard chalk, Blackboard is as easy to re-use as it is to apply. Simply wipe clean with a damp cloth to start again! There are countless ways to advertise, organize, and customize with BlackBoard heat transfer vinyl.
    BlackBoard® Black  

Blackboard Applies To:

Cricut:   Blade: Standard   Setting: Paper
Silhouette Cameo:   Blade: Standard, 2   Material: Heat Transfer, Smooth   Speed: 5   Force: 8
Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1   Cut Pressure: 1


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Roland GX/GS-24:   Blade: 45°   Gram Force: 70-80   Offset: .250   Speed: 50 cm/s
Graphtec:   Blade: 45°   Force: 7-8   Tool: CB09U+0   Speed: 50 cm/s
MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s    *Blade Advancing Varies
Titan 2 & 3:    Blade: 45°/60°    Gram Force: 60-65   Speed: 300 mm/s   *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 10 seconds
• Peel carrier warm		 Application Instructions (heat press)

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 275°F/135°C
• Use medium pressure for 15 seconds
• Peel carrier warm

Click here for a printable version of all HTV application instructions

Recommended Accessories:

Siser Weeder
Multipurpose Paper or Heat Transfer Cover Sheet

Laundering:

Wait 24 hours before first wash
Machine wash cold / mild detergent
Dry on normal dryer setting
Do not dry clean