Shining statements, multicolor combinations, and no sew projects can all be achieved with EasyWeed Adhesive! Compatible with cost-effective screen printing foils and other materials that lend themselves to adhesion, this adhesive is a money saver and a money maker! Even on its own, EasyWeed Adhesive creates a glazed tone on tone appearance that’s trending. The milky colored adhesive features a pressure sensitive carrier and low application temperature that’s gentle enough for almost all heat sensitive fabrics. Cutting EasyWeed Adhesive is like any other EasyWeed product with the shiny, carrier side face down and image mirrored. For best visibility while weeding, we suggest placing the adhesive on a dark surface.
EasyWeed Adhesive is 75 Microns / 2.95 Mils and is a PET Composition.
EasyWeed Adhesive Applies to:
Settings for Craft Cutters
Cricut® Explore Air
Cricut® Maker
Brother® Scan N Cut DX
Silhouette Cameo® 4
Blade: AutoBlade, Standard
Setting: Vinyl +
Blade: AutoBlade, Fine-Point
Setting: Heat Transfer (Non-Cricut)
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.
Application Instructions
Home Iron Instructions
• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and
re-press for 5-10 seconds
• Peel carrier hot
Heat Press Instructions
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 275°F/135°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot