EasyWeed® Electric Heat Transfer Vinyl

Electrify Your Look With Unique Finishes

If you’re looking to take your designs to the next level, EasyWeed Electric has a finish or pattern just for you! You’ve never seen a heat applied material like EasyWeed Electric. The colors are vibrant with a pearlescent metallic sheen. EasyWeed Electric comes on a pressure-sensitive carrier which makes cutting detailed designs and logos a breeze. EasyWeed Electric is durable wash after wash and maintains its bright color and brilliant finish. If you’re looking to provide multi-color designs, EasyWeed Electric can be layered.

EasyWeed Electric is 90 Microns / 3.5 Mils and is a PU composition.




EasyWeed® Electric Pearl   EasyWeed® Electric White Opal   EasyWeed® Electric Tungsten   EasyWeed® Electric Copper   EasyWeed® Electric Cranberry   EasyWeed® Electric Red   EasyWeed® Electric Orange   EasyWeed® Electric Yellow
EasyWeed® Electric Lime   EasyWeed® Electric Green   EasyWeed® Electric Olive   EasyWeed® Electric Teal   EasyWeed® Electric Peacock Teal   EasyWeed® Electric Spearmint   EasyWeed® Electric Blue   EasyWeed® Electric Columbia Blue
EasyWeed® Electric Frosted Blueberry   EasyWeed® Electric Grape   EasyWeed® Electric Purple   EasyWeed® Electric Cherry   EasyWeed® Electric Pink   EasyWeed® Electric Rose Gold   EasyWeed® Electric Silver Lens   EasyWeed® Electric Gold lens

EasyWeed Electric Applies to:

   Cricut:   Blade: Standard   Setting: Iron-on

Silhouette Cameo:   Blade: Standard, 2   Material: Heat Transfer, Smooth   Speed:  Force: 4

Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1   Cut Pressure: 1


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Roland GX/GS-24:   Blade: 45°   Gram Force: 80-90   Offset: .250   Speed: 25-50 cm/s

Graphtec:   Blade: 45°   Force: 8-9    Tool: CB09+0   Speed: 30 cm/s

MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s   *Blade Advancing Varies

Titan 2 & 3:    Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s    *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold

Click here for a printable version of all HTV application instructions

Recommended Accessories:

Siser Weeder
Multipurpose Paper or
Kraft Paper or
Heat Transfer Cover Sheet

Laundering:

Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean