EasyWeed Glow

EasyWeed® Glow Heat Transfer Vinyl

Create Custom Designs that Glow in the Dark!

EasyWeed Glow looks great in the daylight and glows in the dark! This polyurethane heat transfer vinyl is available in white and glows green! It cuts and weeds like our popular EasyWeed heat transfer vinyl. To get the glow effect, "charge" the material by exposing it to sunlight. The more light you give it, the brighter and longer it glows in the dark! Glow is great for crafters looking to create costumes, candy bags, and cool blanket forts that shine at bedtime. EasyWeed Glow can even be layered on other Siser® materials for an awesome look. Layering EasyWeed Glow on top of white EasyWeed lets you create hidden messages and effects that reveal themselves in the dark!


EasyWeed Glow is CPSIA Certified so even your little ones can get in on the glow in the dark fun!



EasyWeed Glow in the Dark features

  EasyWeed Glow Shirt Design
    EasyWeed® Glow in the Dark  

EasyWeed  Glow Applies to:




Craft Cutter Settings


    Cricut:
Blade: Standard    Setting: Iron-on

    Silhouette Cameo:    
Blade:
Standard, 2    Material: Heat Transfer, Smooth    Speed: 8    Force: 4

    Brother ScanNCut:    
Blade:
Standard, 2    Cut Speed: 1    Cut Pressure: 1


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.




Pro Cutter Settings


    Roland GX/GS-24:
Blade: 45°    Gram Force: 80-90    Offset: .250    Speed: 25-50 cm/s

    Graphtec:    
Blade:
45°    Force: 8-9    Tool: CB09+0    Speed: 30 cm/s

    MH, SC2, LP3, and Titan 1:    
Blade:
45°/60°    Gram Force: 80-85    Speed: 300 mm/s *Blade Advancing Varies

    Titan 2 & 3:    
Blade:
45°/60°    Gram Force: 80-85    Speed: 300 mm/s *Blade Advancing Varies

    Mimaki CG-60SR III:    
Blade:
45°    Gram Force: 80    Offset: 30    Speed: 20-30 cm/s


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.




Application Instructions


Home Iron Instructions

• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and
re-press for 5-10 seconds
• Peel carrier hot or cold

Heat Press Instructions     

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• If areas of design lift after application, replace cover sheet and
re-press for 5-10 seconds
• Peel carrier hot or cold

Click here for a printable version of all HTV application instructions




Recommended Accessories:

Siser Weeder
Multipurpose Paper or
Heat Transfer Cover Sheet

Laundering:

Wait 24 hours before first wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean


EasyWeed Glow in the Dark Design