Holographic

Holographic Heat Transfer Vinyl

A new dimension in heat transfer vinyl!

Holographic contains color changing chips that create the effect of depth and dimension. Available in several special effect colors and finishes, Holographic will take your designs to a new level. Love the look of rhinestones but don’t want to go through all the hassle? Holographic can be cut to look exactly like rhinestones, without having to go through all the extra work associated with applying rhinestone designs. The Holographic line also features a translucent color: Rainbow Pearl. Rainbow Pearl is unlike any other material, giving your designs an opalescent finish that changes depending on the color of the garment. Check out this blog post on working with Holographic.

Holographic is 110 Microns / 4.3 Mils and is a Polyester composition.



Holographic Features

Holographic Shirt Design
Holographic Silver   Holographic Black   Holographic Red   Holographic Orange   Holographic Gold   Holographic Green   Holographic Sky   Holographic Aqua
Holographic Royal Blue   Holographic Navy Blue   Holographic Purple   Holographic Fuchsia   Holographic Light Pink   Holographic Crystal   Holographic Gold Crystal   Holographic Rainbow
Holographic Rainbow Pearl              

Holographic Applies to:




Craft Cutter Settings


    Cricut:
Blade: Standard    Setting: Light cardstock

    Silhouette Cameo:    
Blade:
Standard, 3    Material: Heat Transfer, Smooth    Speed:     Force:  14

    Brother ScanNCut:    
Blade:
Standard, 2    Cut Speed: 1    Cut Pressure: 3


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.




Pro Cutter Settings


    Roland GX/GS-24:
Blade: 45°    Gram Force: 180-190    Offset: .250    Speed: 30 cm/s

    Graphtec:    
Blade:
45°    Force: 17-18    Tool: CB09+0    Speed: 30 cm/s

    MH, SC2, LP3, and Titan 1:    
Blade:
45°/60°    Gram Force: 85-90    Speed: 300 mm/s *Blade Advancing Varies

    Titan 2 & 3:    
Blade:
45°/60°    Gram Force: 75-80    Speed: 300 mm/s *Blade Advancing Varies

    Mimaki CG-60SR III:    
Blade:
45°    Gram Force: 120    Offset: 30    Speed: 20-30 cm/s


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.




Application Instructions


Home Iron Instructions

• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and
re-press for 5-10 seconds
• Peel carrier cold

Heat Press Instructions     

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 320°F/160°C
• Use medium pressure for 15-20 seconds
• Peel carrier cold

Click here for a printable version of all HTV application instructions




Recommended Accessories:

Siser Weeder
Multipurpose Paper or
Heat Transfer Cover Sheet

Laundering:

Wait 24 hours before first wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean


Holographic Design