Sparkle HTV

Sparkle Heat Transfer Vinyl

Make Your Designs Shimmer and Sparkle!

Sparkle™ Heat Transfer Vinyl is a fashionable alternative to Glitter HTV by Siser®. Specially constructed to be soft to the touch, each color includes silver glitter flakes embedded in the material so designs have a smooth finish. Sparkle is available in 14 colors, including gold and silver. Looking to layer? Sparkle can be layered for ultimate bling! Think outside the box and use Sparkle HTV on shoes, belts, and other hard-to-print items. If you like to keep it simple, Sparkle can be applied to t-shirts, hoodies, sweats and scrubs too!





Sparkle Features

Sparkle Shirt Design
Sparkle Midnight Black   Sparkle Sunsest Orange   Sparkle Buttercup Yellow   Sparkle Green Leaf   Sparkle Cornflower Blue   Sparkle Blue Jeans   Sparkle Grapevine   Sparkle Perfect Pink
Sparkle Pink Lemonade   Sparkle Clear Sparkle                        

Sparkle Applies To:

Cricut:   Blade: Standard   Setting: Iron-on

Silhouette Cameo:   Blade: Standard, 2   Material: Heat Transfer, Smooth   Speed: 8 Force: 4

Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1   Cut Pressure: 1


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Roland GX/GS-24:   Blade: 45°   Gram Force: 80-90   Offset: .250   Speed: 25-50 cm/s

Graphtec:   Blade: 45°   Force: 8-9   Tool: CB09+0   Speed: 30cm/s

MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 80-85   Speed: 300mm/s    *Blade Advancing Varies

Titan 2 & 3:    Blade: 45°/60°    Gram Force: 80-85   Speed: 300mm/s   *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)

• Cut in reverse
• Weed excess material
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold

Click here for a printable version of all HTV application instructions

Recommended Accessories:

Siser Weeder
Multipurpose Paper or
Kraft Paper or
Heat Transfer Cover Sheet

Laundering:

• Wait 24 hours before 1st wash
• Machine wash warm or cold / mild detergent
• Dry on normal dryer setting
• Do not dry clean