High Temperature Application: 356°F/180°C)
• Pre-heat substrate for 2 seconds to remove moisture,
smooth wrinkles and warm the substrate to allow the HTV
adhesive to flow a bit easier.
• Tack/apply the HTV to the substrate for 1-2 seconds, then peel
hot/warm. This step is meant to hold the HTV in place on the
substrate in preparation for the next steps.
• Place the printed and mirrored sublimation paper design
side down onto the HTV and heat apply for 45 seconds Peel hot,
many times the paper will release off on its own. |
Low Temperature Application: 320°F/160°C)
• Pre-heat substrate for 2 seconds to remove moisture,
smooth wrinkles and warm the substrate to allow the HTV
adhesive to flow a bit easier.
• Tack/apply the HTV to the substrate for 1-2 seconds, then peel
hot/warm. This step is meant to hold the HTV in place on the
substrate in preparation for the next steps.
• Place the printed and mirrored sublimation paper design
side down onto the HTV and heat apply for 30 seconds Peel hot,
many times the paper will release off on its own. |